DashSkin Dash Cover Compatible with 2000-2006 Chevrolet Tahoe Suburban Yukon Avalanche & 99-06 Chevy Silverado GMC Sierra in Dark Pewter (Dark Grey) - Hard Molded Plastic Dashboard Cap

Looks great. Easy to install. Make sure to follow the directions. Looks OEM. Actually stopped my dash rattles. Well worth the price.

Amazing product! I had low expectations that this would look right after install. Once installed with the easy instructions, it looks like the original equipment. It fit nice and snug, covering all the angles and curves. If you follow the instructions and make sure the surface is prepped properly, you will have an almost original factory look. 5 stars for the easy to read directions and skin fit. Thanks to DashSkin my 2004 Chevy Silverado interior and dash have a good as new look.

This is an EXCELLANT remedy for a cracked dash. Mine was broken into 6 pieces (bought it like that) If you just follow the instructions it was a piece of cake and LOOKS AWESOME ....PERFECT fit , no cutting here or trimming there . Highly recommend this product.

Product is good quality. Called service and spoke to Joel. These folks are down to earth and sincere. He even called me back later in the day to assure that I was all set. If you've never done this before, listen up and this will be easier for you, than it was for me: A. First, do a proper dry run. Check every area to assure that you're not trying to push it into place. On the left of my dash the fit was just a bit too tight. I had camera wires in the way and I should have trimmed the edges just a little in advance. I dealt with it after the fact but I caused myself unnecessary stress and effort. B. I kept reading about how much glue to use and in the end, I under did it. The entire length of the wind screen was sort of floating in the air. Added to my failure was that I didn't use sufficient weight, while it was drying. Joel suggested trying a shim concept. I wound up trying a rubber door jam draft preventer with a sticky back, which saved me from having to try and remove the entire dashskin and it has worked pretty well thus far. The product comes with a tube of glue and I recommend using nearly the entire tube and weighing down the entire dash with something fairly substantial. The install is fairly easy but don't cut corners.

This cover came in a large sturdy box, well packed, came with instructions and only one squieze tube of glue. You will need a tube of clear silicon rtv glue and a good solvent to clean up top of your dash and the bottom of the skin. in my case, the dashboard was broken in two and cracked in several places so i had to remove it to repair it. the clips by the windshield all broken off It is a very easy job, 1/2 hour to remove another 1/2 to install and one whole day to repair and let glues cure. you need a 7mm socket, a stubby #2 philips and a regular one, two of those plastic spatulas to remove the trimming and also like i said before a tube of silicon glue with it's gun. The color was a very good match.

Fit like a glove! Easy to install, fast cure time. Color matched 👌. Price was reasonable. The air vents in my dash were cracked and broken. The new skin slid right over the old. Double layer of protection!

Easy to install. Dramatically changed to look of the interior. Dash had lots of cracks in it. Now looks like when I got the truck 200,000 miles ago. Note: remove any broken dash parts so they don't rattle under the cover. It took a few more minutes but the end result was worth it.

Purchased dash skin for a 2007 Tahoe great fit, color and texture was close to perfect. The dash skin I recently purchased for my 2005 Avalanche fits ok,the color is a little off but the texture is not consistent throughout the cover. Installed anyway, wish I would have returned for a replacement. These covers, however, are good problem solvers for a cracked dash. Inspect carefully before installation. I install the second one late in the evening without a quality check since the first one I purchased exceeded my expectations.